As an Amazon Associate, I earn from qualifying purchases. This post contains affiliate links. If you click through and make a purchase, I may earn a commission at no additional cost to you.
🏆 RECOMMENDED PART
Washer Suspension Rods Kit (4 Pack)
Check Price
- Supports the washer tub, acts as a shock absorber to reduce vibration and keep the washing machine stable.
- Kit includes 4 W10780045 suspension rods (approx. 24.3 inches), 4 suspension balls, and 4 suspension ball housings.
- Compatible with Whirlpool, Kenmore, Amana, Maytag, and other major washing machine brands.
- Replaces part numbers W10537442, W10537443, W10780053, and more.
- Designed for simple DIY installation, typically completed in under 30 minutes. Backed by a 5-year guarantee.
Prices are accurate as of the date of publication and are subject to change.
What the W10780045 does
The W10780045 is a kit of 4 suspension rods that hold the inner tub of a top load washer. Each rod has a spring and a friction ball that absorbs spin cycle vibration. Over years of use the friction grease dries out, the rods stop dampening, and the drum bangs against the cabinet.
Symptoms when this part fails
- Top load washer shaking violently during spin
- Loud banging from inside the cabinet on spin
- Drum visibly bouncing when pushed down and released
- Machine walks across the floor
Compatibility
Fits the Whirlpool, Kenmore, Maytag, Amana (top load) family. Specifically:
- Whirlpool top load washers WTW4616, WTW4800, WTW4850 series
- Maytag top load washers MVW series (most)
- Kenmore top load washers built on the Whirlpool platform (110. prefix)
- Amana NTW series
- Most Whirlpool family top loaders built 2010 to present
Also replaces: W10537442, W10537443, W10780053
Tools you'll need
- 7/16 inch socket and ratchet
- Putty knife (to release cabinet hinges)
- Phillips screwdriver
Difficulty: Intermediate · Time: 30 to 60 minutes for the full set
How to install the W10780045, step by step
- Unplug the washer and disconnect the water hoses
- Pop the cabinet hinges with a putty knife (top corners on most models)
- Tilt the cabinet forward and rest it against a wall
- Locate the 4 suspension rods, one at each corner of the inner tub
- Compress each rod by hand to unseat it from the upper bracket
- Remove the old rod, swap in the new one
- Verify the new rod compresses smoothly and seats fully in the bracket
- Reattach the cabinet, test on a small load to confirm balance
Related troubleshooting
If swapping this part doesn't fix the issue, check these next: