As an Amazon Associate, I earn from qualifying purchases. This post contains affiliate links. If you click through and make a purchase, I may earn a commission at no additional cost to you.
🏆 RECOMMENDED PART
Frigidaire 316075103 Oven Bake Element for Electric Ranges
Check Price
- OEM Frigidaire 316075103, also fits Kenmore, Tappan, Gibson, and other Electrolux family ranges.
- Common fix when the oven preheats forever and never reaches temp, or only the broiler works.
- Bolts in with two screws and two wire connectors, 10 minute install.
- Visually inspect the old element first, look for blisters, breaks, or burn marks.
- Make sure to flip the breaker before swapping, the terminals carry 240V.
Prices are accurate as of the date of publication and are subject to change.
What the 316075103 does
The 316075103 is the bake element on most Frigidaire family electric ovens. A 240V heating coil that sits at the bottom of the oven cavity. When the coil burns through (visible blister or break), the oven preheats forever or never reaches set temperature, and only the broil function works.
Symptoms when this part fails
- Oven preheats forever and never reaches set temperature
- Only the broiler heats, the bake function is dead
- Visible blister, break, or burn mark on the bottom heating element
- Element tests as open circuit (no continuity) on a multimeter
Compatibility
Fits the Frigidaire, Kenmore, Tappan, Gibson, Electrolux family. Specifically:
- Frigidaire electric ranges FFEF, FCRE, FFGF, FGEF series
- Kenmore electric ranges built on the Frigidaire platform (790. prefix)
- Tappan and Gibson branded ranges
- Electrolux EW series electric ovens
- Most Frigidaire family ranges built 2000 to present
Also replaces: AP4356505, PS2378323, 316282600
Tools you'll need
- Phillips screwdriver
Difficulty: Beginner · Time: 10 to 15 minutes
How to install the 316075103, step by step
- Turn off the breaker for the oven (240V circuit, do not skip this)
- Remove the oven racks for clearance
- Locate the 2 mounting screws holding the bake element bracket to the back wall
- Remove the screws and pull the element forward 2 to 3 inches
- Disconnect the 2 wire spade connectors at the back of the element
- Connect the 2 wires to the new element terminals
- Push the element back against the wall and reattach the mounting screws
- Restore power, run the oven on bake at 350 F for 15 minutes to confirm
Related troubleshooting
If swapping this part doesn't fix the issue, check these next: