Appliance Aid takes part in the Amazon Associates programme. Some links on this page are affiliate links, and a qualifying purchase earns us a commission. Your price is unchanged.
🏆 RECOMMENDED PART
DC61-02627A Dryer Moisture Sensor Plate Bar for Samsung Replacement Part -2
- DC61-02627A Moisture Plate Sensor Fits for Samsung Kenmore Dryer.
- DC61-02627A Dryer moisture sensor Replace for part numbers:2069516, AP4578789, PS4206812, EAP4206812, PD00023015.
- Moisture sensor DC61-02627A detects the amount of moisture in the laundry load.This sensor is an essential part of any modern dryer, and it is important to choose a sensor that is durable and accurate.
- Disconnect the power before installing this part. Wear work gloves to protect your hands.
- Any questions not completely satisfied, please contact us, you can have or exchange within 30 days.
What the DC61-02627A does
This part detects the moisture level of clothes during a drying cycle. It signals the control board to determine when clothes are dry and to end the cycle.
Symptoms when this part fails
- Dryer runs too long
- Clothes are still damp after cycle
- Dryer stops too early
- Error codes related to moisture sensing
Compatibility
Fits the Samsung family. Specifically:
- Any unit originally equipped with OEM part number(s): 2069516, AP4578789, PS4206812, EAP4206812, PD00023015.
- Check the model/rating plate inside your appliance and compare it against the fitment table on the product listing before ordering — this guide does not list specific compatible models because Amazon does not provide verified fitment data through this pipeline.
Also replaces: 2069516, AP4578789, PS4206812, EAP4206812, PD00023015
Tools you'll need
- Phillips screwdriver
- Flathead screwdriver
- Nut driver
Difficulty: Moderate · Time: 30-60 minutes
How to install the DC61-02627A, step by step
- Disconnect dryer from power supply.
- Remove the top panel screws and lift the panel.
- Remove screws securing the front panel.
- Carefully detach the front panel, noting wire connections.
- Locate the moisture sensor strip, typically on the front bulk head.
- Disconnect the electrical connector and remove mounting screws.
- Install the new moisture sensor strip and reconnect wires.
- Reassemble the dryer panels in reverse order.
Related troubleshooting
If swapping this part doesn't fix the issue, check these next: